Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
cam:x350 [2023/02/10 12:50] – [Touch_sensor] gigo | cam:x350 [2023/03/11 22:58] (current) – [Timeline] gigo | ||
---|---|---|---|
Line 202: | Line 202: | ||
== Timeline | == Timeline | ||
+ | * 2023/03/11: calibrated z-axis, calibrated pressure advance, printed another benchy without imporoved results. | ||
* 2023/02/09: after eye-balling the calibration of the z-axis and redoing a proper bed leveling: first " | * 2023/02/09: after eye-balling the calibration of the z-axis and redoing a proper bed leveling: first " | ||
* 2023/02/07: Install & calibrate new 3D-Touch sensor, add klipper config to gitlab repo | * 2023/02/07: Install & calibrate new 3D-Touch sensor, add klipper config to gitlab repo | ||
Line 222: | Line 223: | ||
== ToDo: | == ToDo: | ||
- | * proper calibration of the z-axis (don't forgert to calibrate z-endstop | + | * proper calibration of the z-axis (don't forgert to calibrate z-endstop, probe offset |
* cable management | * cable management | ||
* klipper calibrations: | * klipper calibrations: |